![]() System plugged in, but either turned off or in Windows Hibernation State. This is actually a BIOS controlled state and is also S0e. System is not plugged into AC, PSU is not plugged into system board, or control panel not connected to system board. Pre-POST (Power On Self Test) diagnostic LED patternsÄepending on the system, the normal power-on state may be either a solid white, green, or blue power LED. The BIOS will turn the LED to this state to indicate it has started fetching operation codes. System is in S0 state, the normal power state of a functioning machine. Look at the diagnostic LEDs to determine which state the system is in. System is in a low power state, either S1 or S3. Look at the diagnostic LEDs for further information. Indicates the POWER_GOOD signal is active and it is probable that the power supply is fine. If the Hard Drive LED is on, it is probable that an onboard regulator or VRM has failed. If the Hard Drive LED is off, it is probable that the power supply needs to be replaced. Indicates system has power, but the POWER_GOOD signal is not yet active. For a more detailed description of the POST process and how to troubleshoot issues with the system powering on and booting to Windows, refer to the article Why Won't my Desktop Computer Turn On? at the Dell support site. These LEDs do not indicate the problem that caused the POST routine to stop. The diagnostic LEDs only serve as an indicator of the progress through the POST (Power On Self-Test) process. Use the chart below as a reference for the different LED patterns and the possible system issues they indicate. Each LED has three possible states: OFF, ON, or BLINKING. The configuration of these LEDs along with the color state of the power button can help pinpoint a potential problem with the system. Once the operating system starts to load, they turn off and are no longer visible. These diagnostic LEDs are only active and visible during the Power On Self-Test (POST) process. The LEDs are located beneath the headphone and microphone jacks. The diagnostic LEDs are located on the front of the chassis and numbered 1, 2, 3, 4. Location and purpose of the power button LED and the diagnostic LEDs. Pre-POST (Power On Self Test) diagnostic LED patterns.Location and purpose of the power button LED and the diagnostic LEDs.This article provides information on the power and diagnostic LED configuration status for the Precision Workstation T3610/T5610/T7610 systems.
0 Comments
Leave a Reply. |